Odd Fellow's Quilt Block

A free cutting chart for 7½", 10" and 12½" blocks, the units it is made of, and how to sew it, worked out by the same code that writes Quiltler's printable patterns.

Odd Fellow's is a five-by-five grid of seventeen chain squares and eight background squares. The chain fills the middle row and column, and each corner quarter is a four-patch, all four set the same way.

  • 5 × 5 grid
  • 7½", 10" and 12½" finished
  • 2 fabrics
The Odd Fellow's block as the Quiltler studio draws it.

What the Odd Fellow's block is made of

Every shape in a 12½" block, by fabric, at its finished size.

FabricFinished shapes
Background8 squares (2½")
Chain17 squares (2½")

The pattern sews it from 4 strip-set segments (strip set 1).

Odd Fellow's cutting chart

Cut sizes for one block at 7½", 10" and 12½" finished, with a ¼" seam allowance. These are the numbers a Quiltler pattern prints for the block: squares and rectangles are cut ½" larger than they finish, half-square triangles from squares ⅞" larger, and hourglasses and flying geese from squares 1¼" larger. Unit codes (H1, G1 and so on) match the sewing steps below.

WOF is the width of the fabric, 42" after the selvages are trimmed.

7½" finished block (1½" grid, 8" unfinished)

FabricCutFor
Background1 strip 2" × WOF (2 half length)Strip set 1
Chain1 strip 3½" × WOF (half length is enough)Strip set 1
Chain1 strip 2" × WOF (half length is enough)Strip set 1
Chain5 squares 2"Finishes at 1½" square

10" finished block (2" grid, 10½" unfinished)

FabricCutFor
Background1 strip 2½" × WOF (2 half length)Strip set 1
Chain1 strip 4½" × WOF (half length is enough)Strip set 1
Chain1 strip 2½" × WOF (half length is enough)Strip set 1
Chain5 squares 2½"Finishes at 2" square

12½" finished block (2½" grid, 13" unfinished)

FabricCutFor
Background1 strip 3" × WOF (2 half length)Strip set 1
Chain1 strip 5½" × WOF (half length is enough)Strip set 1
Chain1 strip 3" × WOF (half length is enough)Strip set 1
Chain5 squares 3"Finishes at 2½" square

How to sew a 12½" Odd Fellow's block

Sew the strip sets

  1. Sew 4 strips together along their long edges in this order: Chain – Background – Chain – Background. Sew each seam in the opposite direction to the last so the set stays straight instead of bowing.
  2. Press every seam to one side, toward the darker fabric where you can.
  3. Make 1 half-length set from strips cut in half.
  4. Trim one end square, then crosscut 4 segments 3" wide. Square the end again every few cuts.
  5. Use the segments for rows 1, 2, 4 and 5 of the block.
  6. Where a row reads the other way round, turn the segment end for end before sewing it in.

Sew the block

  1. The block takes 4 segments of strip set 1.
  2. Sew each row of the center together as the drawing shows. Press the seams in alternate directions row to row so they nest.
  3. Join the rows, matching the seams where they meet.
  4. The block should measure 13" square including seam allowance. Check it against the drawing.

Check as you go: measure each unit before you sew it into a row. A unit that is a little small is easier to remake than a block that will not lie flat.

How many Odd Fellow's blocks for a quilt?

With 12½" blocks set edge to edge, no sashing and no border, the nearest whole number of blocks to the studio's throw and queen sizes:

QuiltBlocks across × downBlocksFinished top
Throw (60" × 72")5 × 63062½" × 75"
Queen (90" × 108")7 × 96387½" × 112½"

Sashing and borders change the count. The quilt size calculator works it out for any block size, and the quilt sizes guide lists bed sizes.

Design with this block

Open the designer, press Go to Blocks at the top of the right panel, pick Classics and search for Odd Fellow's. Click the block, then click a space on the quilt. It lands as ordinary pieces, so you can recolor any part of it.

Open the designer

The yardage and a printable pattern with this cutting chart come from the quilt you design. How to put a block on a quilt · Add a classic block to your library

Every classic block in the studio is in the quilt block library.

Calculators and guides for this block

Odd Fellow's block FAQ

What do I cut for a 12½" Odd Fellow's block?

For one 12½" finished Odd Fellow's block, with a quarter-inch seam: Background: 1 strip 3" × WOF (2 half length). Chain: 1 strip 5½" × WOF (half length is enough); 1 strip 3" × WOF (half length is enough); 5 squares 3".

How many Odd Fellow's blocks make a throw quilt?

At 12½" finished, 5 blocks across and 6 down, 30 in all, make a 62½" × 75" top with no sashing or border.

What sizes can a Odd Fellow's block be?

It is drafted on a 5 × 5 grid, so it works at any size that grid divides evenly. 7½", 10" and 12½" give 1½", 2" and 2½" squares of the grid.

Design a Odd Fellow's quilt

Lay the block out, try it in your own fabrics, and get the yardage and a printable pattern from the quilt you draw.

Design Online — Free Or get the companion app