Prairie Queen Quilt Block

A free cutting chart for 6", 9" and 12" blocks, the units it is made of, and how to sew it, worked out by the same code that writes Quiltler's printable patterns.

Quiltler's Prairie Queen is a six-by-six block of eight four-patches set around a plain light center square the size of one four-patch.

  • 6 × 6 grid
  • 6", 9" and 12" finished
  • 2 fabrics
The Prairie Queen block as the Quiltler studio draws it.

What the Prairie Queen block is made of

Every shape in a 12" block, by fabric, at its finished size.

FabricFinished shapes
Light1 square (4") and 16 squares (2")
Dark16 squares (2")

The pattern sews it from 8 strip-set segments (strip set 1).

Prairie Queen cutting chart

Cut sizes for one block at 6", 9" and 12" finished, with a ¼" seam allowance. These are the numbers a Quiltler pattern prints for the block: squares and rectangles are cut ½" larger than they finish, half-square triangles from squares ⅞" larger, and hourglasses and flying geese from squares 1¼" larger. Unit codes (H1, G1 and so on) match the sewing steps below.

WOF is the width of the fabric, 42" after the selvages are trimmed.

6" finished block (1" grid, 6½" unfinished)

FabricCutFor
Light1 strip 1½" × WOF (half length is enough)Strip set 1
Light1 square 2½"Finishes at 2" square
Light8 squares 1½"Finishes at 1" square
Dark1 strip 1½" × WOF (half length is enough)Strip set 1
Dark8 squares 1½"Finishes at 1" square

9" finished block (1½" grid, 9½" unfinished)

FabricCutFor
Light1 strip 2" × WOF (half length is enough)Strip set 1
Light1 square 3½"Finishes at 3" square
Light8 squares 2"Finishes at 1½" square
Dark1 strip 2" × WOF (half length is enough)Strip set 1
Dark8 squares 2"Finishes at 1½" square

12" finished block (2" grid, 12½" unfinished)

FabricCutFor
Light1 strip 2½" × WOF (half length is enough)Strip set 1
Light1 square 4½"Finishes at 4" square
Light8 squares 2½"Finishes at 2" square
Dark1 strip 2½" × WOF (half length is enough)Strip set 1
Dark8 squares 2½"Finishes at 2" square

How to sew a 12" Prairie Queen block

Sew the strip sets

  1. Sew 2 strips together along their long edges in this order: Dark – Light.
  2. Press every seam to one side, toward the darker fabric where you can.
  3. Make 1 half-length set from strips cut in half.
  4. Trim one end square, then crosscut 8 segments 2½" wide. Square the end again every few cuts.
  5. Use the segments for rows 1, 2, 3, 4 and 5 of the block.
  6. Where a row reads the other way round, turn the segment end for end before sewing it in.

Sew the block

  1. The block takes 8 segments of strip set 1.
  2. Sew each row of the block together left to right, as the drawing shows. Press the seam allowances in alternate directions row to row so they nest.
  3. Join the rows, matching the seams where they meet.
  4. The block should measure 12½" square including seam allowance. Check it against the drawing.

Check as you go: measure each unit before you sew it into a row. A unit that is a little small is easier to remake than a block that will not lie flat.

How many Prairie Queen blocks for a quilt?

With 12" blocks set edge to edge, no sashing and no border, the nearest whole number of blocks to the studio's throw and queen sizes:

QuiltBlocks across × downBlocksFinished top
Throw (60" × 72")5 × 63060" × 72"
Queen (90" × 108")8 × 97296" × 108"

Sashing and borders change the count. The quilt size calculator works it out for any block size, and the quilt sizes guide lists bed sizes.

Design with this block

Open the designer, press Go to Blocks at the top of the right panel, pick Classics and search for Prairie Queen. Click the block, then click a space on the quilt. It lands as ordinary pieces, so you can recolor any part of it.

Open the designer

The yardage and a printable pattern with this cutting chart come from the quilt you design. How to put a block on a quilt · Add a classic block to your library

Every classic block in the studio is in the quilt block library.

Calculators and guides for this block

Prairie Queen block FAQ

What do I cut for a 12" Prairie Queen block?

For one 12" finished Prairie Queen block, with a quarter-inch seam: Light: 1 strip 2½" × WOF (half length is enough); 1 square 4½"; 8 squares 2½". Dark: 1 strip 2½" × WOF (half length is enough); 8 squares 2½".

How many Prairie Queen blocks make a throw quilt?

At 12" finished, 5 blocks across and 6 down, 30 in all, make a 60" × 72" top with no sashing or border.

What sizes can a Prairie Queen block be?

It is drafted on a 6 × 6 grid, so it works at any size that grid divides evenly. 6", 9" and 12" give 1", 1½" and 2" squares of the grid.

Design a Prairie Queen quilt

Lay the block out, try it in your own fabrics, and get the yardage and a printable pattern from the quilt you draw.

Design Online — Free Or get the companion app