Practical Orchard Quilt Block

A free cutting chart for 6", 9" and 12" blocks, the units it is made of, and how to sew it, worked out by the same code that writes Quiltler's printable patterns.

Practical Orchard is a six-by-six block of eight four-patches around a single hourglass unit in the center, so it reads as a checkerboard with an hourglass in the middle.

  • 6 × 6 grid
  • 6", 9" and 12" finished
  • 2 fabrics
The Practical Orchard block as the Quiltler studio draws it.

What the Practical Orchard block is made of

Every shape in a 12" block, by fabric, at its finished size.

FabricFinished shapes
Background2 quarter-square triangles (4") and 16 squares (2")
Accent2 quarter-square triangles (4") and 16 squares (2")

The pattern sews it from 8 strip-set segments (strip set 1).

Practical Orchard cutting chart

Cut sizes for one block at 6", 9" and 12" finished, with a ¼" seam allowance. These are the numbers a Quiltler pattern prints for the block: squares and rectangles are cut ½" larger than they finish, half-square triangles from squares ⅞" larger, and hourglasses and flying geese from squares 1¼" larger. Unit codes (H1, G1 and so on) match the sewing steps below.

WOF is the width of the fabric, 42" after the selvages are trimmed.

6" finished block (1" grid, 6½" unfinished)

FabricCutFor
Background1 strip 1½" × WOF (half length is enough)Strip set 1
Background1 square 3¼", cut twice on the diagonalquarter-square triangles, each finishing in a 2" square
Background8 squares 1½"Finishes at 1" square
Accent1 strip 1½" × WOF (half length is enough)Strip set 1
Accent1 square 3¼", cut twice on the diagonalquarter-square triangles, each finishing in a 2" square
Accent8 squares 1½"Finishes at 1" square

9" finished block (1½" grid, 9½" unfinished)

FabricCutFor
Background1 strip 2" × WOF (half length is enough)Strip set 1
Background1 square 4¼", cut twice on the diagonalquarter-square triangles, each finishing in a 3" square
Background8 squares 2"Finishes at 1½" square
Accent1 strip 2" × WOF (half length is enough)Strip set 1
Accent1 square 4¼", cut twice on the diagonalquarter-square triangles, each finishing in a 3" square
Accent8 squares 2"Finishes at 1½" square

12" finished block (2" grid, 12½" unfinished)

FabricCutFor
Background1 strip 2½" × WOF (half length is enough)Strip set 1
Background1 square 5¼", cut twice on the diagonalquarter-square triangles, each finishing in a 4" square
Background8 squares 2½"Finishes at 2" square
Accent1 strip 2½" × WOF (half length is enough)Strip set 1
Accent1 square 5¼", cut twice on the diagonalquarter-square triangles, each finishing in a 4" square
Accent8 squares 2½"Finishes at 2" square

How to sew a 12" Practical Orchard block

Sew the strip sets

  1. Sew 2 strips together along their long edges in this order: Accent – Background.
  2. Press every seam to one side, toward the darker fabric where you can.
  3. Make 1 half-length set from strips cut in half.
  4. Trim one end square, then crosscut 8 segments 2½" wide. Square the end again every few cuts.
  5. Use the segments for rows 1, 2, 3, 4 and 5 of the block.
  6. Where a row reads the other way round, turn the segment end for end before sewing it in.

Sew the block

  1. The block takes 1 × C1; make it first.
  2. Make each C1 (Hourglass: Accent top and bottom, Background at the sides) by cutting: sew its four quarter-square triangles into two pairs along a short edge, then sew the pairs together along the long edge, matching the center point, and press.
  3. The block takes 8 segments of strip set 1.
  4. Sew each row of the block together left to right, as the drawing shows. Press the seam allowances in alternate directions row to row so they nest.
  5. Join the rows, matching the seams where they meet.
  6. The block should measure 12½" square including seam allowance. Check it against the drawing.

Check as you go: measure each unit before you sew it into a row. A unit that is a little small is easier to remake than a block that will not lie flat.

How many Practical Orchard blocks for a quilt?

With 12" blocks set edge to edge, no sashing and no border, the nearest whole number of blocks to the studio's throw and queen sizes:

QuiltBlocks across × downBlocksFinished top
Throw (60" × 72")5 × 63060" × 72"
Queen (90" × 108")8 × 97296" × 108"

Sashing and borders change the count. The quilt size calculator works it out for any block size, and the quilt sizes guide lists bed sizes.

Design with this block

Open the designer, press Go to Blocks at the top of the right panel, pick Classics and search for Practical Orchard. Click the block, then click a space on the quilt. It lands as ordinary pieces, so you can recolor any part of it.

Open the designer

The yardage and a printable pattern with this cutting chart come from the quilt you design. How to put a block on a quilt · Add a classic block to your library

Every classic block in the studio is in the quilt block library.

Calculators and guides for this block

Practical Orchard block FAQ

What do I cut for a 12" Practical Orchard block?

For one 12" finished Practical Orchard block, with a quarter-inch seam: Background: 1 strip 2½" × WOF (half length is enough); 1 square 5¼", cut twice on the diagonal; 8 squares 2½". Accent: 1 strip 2½" × WOF (half length is enough); 1 square 5¼", cut twice on the diagonal; 8 squares 2½".

How many Practical Orchard blocks make a throw quilt?

At 12" finished, 5 blocks across and 6 down, 30 in all, make a 60" × 72" top with no sashing or border.

What sizes can a Practical Orchard block be?

It is drafted on a 6 × 6 grid, so it works at any size that grid divides evenly. 6", 9" and 12" give 1", 1½" and 2" squares of the grid.

Design a Practical Orchard quilt

Lay the block out, try it in your own fabrics, and get the yardage and a printable pattern from the quilt you draw.

Design Online — Free Or get the companion app